Custom Tile & Stone Work in Camas, WA
Shower, floor, and wall tile set over real waterproofing.
Custom Tile & Stone Work in Camas starts with understanding the local housing. Camas is one of the Vancouver-metro communities in Clark County that we serve across Southwest Washington.
Camas sits at roughly 82 feet, low on the valley floor, where a high water table and slow-draining ground keep crawlspaces, foundations, and the bottom courses of siding damp well after the rain stops. PRISM's 1991-2020 climate normals put it at about 49.2 inches of precipitation a year. For custom tile & stone work, that matters most in the parts you never see: indoor humidity has few chances to dry out, so exhaust ventilation sized to the room, a continuous vapor and air-control layer, and properly detailed wet-area waterproofing do more for the life of the work than any finish selection. Camas also sits at the western gate of the Columbia River Gorge, where east wind drives rain horizontally into walls that would stay dry elsewhere in the county — so custom tile & stone work here is detailed for wind-driven water, and any James Hardie cladding follows the HZ5 guidance for this zone, all under the Washington State Energy Code.
This page covers custom tile & stone work specifically for Camas. For the full service details, see our Custom Tile & Stone Work page, or explore all the remodeling work we do in Camas.
Camas's housing stock tells the story of a former paper-mill town turned fast-growing suburb. Downtown Camas and the streets closest to the old mill hold smaller early-to-mid-1900s homes with real character and, often, original single-pane windows and dated wiring. Up the hill, Prune Hill and Dawson's Landing are dominated by 1990s-onward and newer custom and semi-custom construction with open layouts and larger lots. Because Camas sits at the mouth of the Columbia River Gorge, homes here see stronger, more consistent wind than communities further from the river, which we factor into siding fastening schedules, flashing details, and exterior trim as much as the region's rain and moisture.
From Downtown Camas, Prune Hill, and Dawson's Landing to the rest of Camas, we match every custom tile & stone work project to the age, construction, and condition of your specific home rather than a one-size-fits-all spec.
- County
- Clark County
- Permitting authority
- City of Camas — Community Development
- Elevation
- 82 ftCopernicus DEM GLO-90 at the city center
- Annual precipitation
- 49.2 inPRISM 1991-2020 normals, 800 m grid at the city center
- Climate zone
- Marine 4CWashington State Energy Code climate zone
- Shower and tub-surround tile over a waterproofing membrane
- Large-format porcelain, subway, mosaic, and natural stone
- Curbless shower pans and linear-drain tile work
- Heated (radiant) tile floors for cold mornings
- Custom niches, benches, and accent bands
- Kitchen and bathroom backsplashes
- Mold-resistant grout and proper sealing for a damp climate
- Uncoupling membranes over subfloors that move
- Slip-resistant floor tile and mosaics
- Natural-stone sealing and long-term care guidance
- 01
Design & Layout
We help you choose tile, pattern, and grout, then lay out the job so full tiles land where the eye goes and cuts are hidden — planning niches, benches, and transitions before anything is set.
- 02
Substrate & Waterproofing
The part that decides how long tile lasts: we prep a flat, sound substrate, add an uncoupling or waterproofing membrane where it's needed, and build a sloped shower pan so water goes to the drain, not the framing.
- 03
Setting & Grouting
Tile is set in the right mortar for the material and location, spaced consistently, then grouted with a mold-resistant product suited to a wet climate and sealed where the material calls for it.
- 04
Seal & Walk-Through
We seal natural stone and grout as needed, clean the surfaces, confirm the shower drains and the room ventilates, and leave you with care guidance for the specific tile you chose.
Typical timeline: Typically a few days to 2 weeks. We provide a written schedule after assessing your Camas home.
Permit requirements for custom tile & stone work in Camas are handled through City of Camas — Community Development. Because Washington building rules — including the Washington State Energy Code and local amendments — vary from one jurisdiction to the next, we confirm what your specific address requires and pull the permits and schedule the inspections the scope calls for.
- Building permits are required for structural, electrical, plumbing, and mechanical work
- Exterior work such as siding, window, and roofing replacement typically requires a permit and inspection
- New construction and most remodels must meet the Washington State Energy Code (WSEC)
- Accessory dwelling units are governed by Washington's statewide ADU law (HB 1337) and city standards — we prepare and submit all applications
Get Your Free Custom Tile & Stone Work Estimate in Camas
Free, no-obligation in-home consultation across Clark County — we respond within one business day with a fixed-price proposal.
Why does tile fail in showers, and how do you prevent it?
Almost every shower-tile failure traces back to waterproofing, not the tile. Tile and grout are not waterproof on their own — water passes through grout lines to whatever is behind them. We set shower tile over a continuous waterproofing membrane on a correctly sloped, sealed base, so the barrier that actually keeps water off the framing is built in. In a climate where showers stay damp much of the year, that detail is what separates a shower that lasts decades from one that rots in a few.
Porcelain, ceramic, or natural stone — which should I choose?
Porcelain is the workhorse: dense, water-resistant, low-maintenance, and available in large formats and stone looks. Ceramic is a budget-friendly wall option. Natural stone (marble, travertine, slate) is beautiful but porous — it needs sealing and more upkeep, which matters more in our damp climate. We'll walk through the trade-offs for each surface in your project.
Can you do heated tile floors?
Yes. An electric radiant mat under tile is one of the most-loved upgrades in a Pacific Northwest bathroom — warm floors on a cold, wet morning. We install the heating system and thermostat as part of the floor build, over the proper underlayment.
Do large-format tiles have fewer maintenance issues?
Generally yes — fewer, thinner grout lines mean less grout to clean and seal, which many homeowners prefer in a climate where bathrooms stay humid. Large-format tile does require a very flat substrate and the right setting method, which is part of what we prep before setting.
Do I need a permit for custom tile & stone work in Camas?
It depends on the scope. City of Camas — Community Development sets the requirements for Camas, and they can differ from neighboring Washington jurisdictions. We confirm what your project needs before we start and handle the permit and inspection process as part of the job.
Do you handle custom tile & stone work on both older and newer Camas homes?
Yes. From Downtown Camas, Prune Hill, and Dawson's Landing to the rest of Camas, Camas in Clark County spans a range of housing eras and construction types, and we tailor the custom tile & stone work plan to the age and condition of your specific home rather than a one-size-fits-all template.
How does Camas's weather affect custom tile & stone work?
Camas averages about 49.2 inches of precipitation a year in PRISM's 1991-2020 climate normals. That is the constraint every detail on a custom tile & stone work project has to answer to: assemblies need a drainage path and the ability to dry, and exterior stages get scheduled around the weather rather than against it. We plan the sequence so nothing is left open to the rain.
What should Camas homeowners know before starting custom tile & stone work?
Two things specific to Camas. First, permits run through City of Camas — Community Development, whose requirements differ from neighboring Washington jurisdictions — we confirm what your address needs before work starts. Second, Camas sits at roughly 82 feet, and that low, slow-draining ground means crawlspace moisture and ground-contact detailing deserve a close look before anything is closed up. Both feed into the written scope and schedule you get before we start.
Ready to Start Your Remodeling Project?
Get a free, no-obligation estimate from Southwest Washington's remodeling and exterior specialists. Licensed, insured, and ready to build.