Custom Tile & Stone Work in Battle Ground, WA

For custom tile & stone work in Battle Ground, the right approach starts with the local housing. Battle Ground is one of the Vancouver-metro communities in Clark County that we serve across Southwest Washington.

Battle Ground spans fast-growing new subdivisions and rural acreage in north Clark County, so custom tile & stone work here means planning for both builder-grade tract homes — where new-construction warranty gaps are common — and older farmhouses, with moisture-smart assemblies throughout under the Washington State Energy Code.

This page covers custom tile & stone work specifically for Battle Ground. For the full service details, see our Custom Tile & Stone Work page, or explore all the remodeling work we do in Battle Ground.

Battle Ground's housing stock mixes an older, smaller-scale core near downtown with newer subdivisions that have followed the city's rapid growth over the past two decades. In-town homes often date from the mid-1900s and need updated wiring, insulation, and windows alongside kitchen and bath work, while newer subdivisions bring open layouts and builder-grade finishes typical of fast-growing north Clark County. As with the rest of the region, long, wet winters make rain-screen siding, proper flashing, and ventilation standard parts of any exterior scope.

From Downtown Battle Ground and Heritage neighborhood to the rest of Battle Ground, we match every custom tile & stone work project to the age, construction, and condition of your specific home rather than a one-size-fits-all spec.

• Shower and tub-surround tile over a waterproofing membrane
• Large-format porcelain, subway, mosaic, and natural stone
• Curbless shower pans and linear-drain tile work
• Heated (radiant) tile floors for cold mornings
• Custom niches, benches, and accent bands
• Kitchen and bathroom backsplashes
• Mold-resistant grout and proper sealing for a damp climate
• Uncoupling membranes over subfloors that move
• Slip-resistant floor tile and mosaics
• Natural-stone sealing and long-term care guidance

1. 01

   Design & Layout

   We help you choose tile, pattern, and grout, then lay out the job so full tiles land where the eye goes and cuts are hidden — planning niches, benches, and transitions before anything is set.

2. 02

   Substrate & Waterproofing

   The part that decides how long tile lasts: we prep a flat, sound substrate, add an uncoupling or waterproofing membrane where it's needed, and build a sloped shower pan so water goes to the drain, not the framing.

3. 03

   Setting & Grouting

   Tile is set in the right mortar for the material and location, spaced consistently, then grouted with a mold-resistant product suited to a wet climate and sealed where the material calls for it.

4. 04

   Seal & Walk-Through

   We seal natural stone and grout as needed, clean the surfaces, confirm the shower drains and the room ventilates, and leave you with care guidance for the specific tile you chose.

Typical timeline: Typically a few days to 2 weeks. We provide a written schedule after assessing your Battle Ground home.

Permit requirements for custom tile & stone work in Battle Ground are handled through City of Battle Ground — Community Development. Because Washington building rules — including the Washington State Energy Code and local amendments — vary from one jurisdiction to the next, we confirm what your specific address requires and pull the permits and schedule the inspections the scope calls for.

• Building permits are required for structural, electrical, plumbing, and mechanical work
• Exterior work such as siding, window, and roofing replacement typically requires a permit and inspection
• New construction and most remodels must meet the Washington State Energy Code (WSEC)
• Accessory dwelling units are governed by Washington's statewide ADU law (HB 1337) — we prepare and submit all applications